#PAINTABLE VEEER PANEL INSTALL#
#PAINTABLE VEEER PANEL FREE#

Apply pressure using a 4-5” J-Roller/Wood Scraper. Our unique BFV backer makes it perfect for nearly any gluing application. Are you sick of painting on Birch or Maple veneer This product gives a superb, seamless and non grain surface for painting. The BFV product is an exclusive patent pending product. If you’re using construction adhesive or wood glue allow for proper curing time (see manufacturer’s recommendation) before cutting or trimming the end panels.įinishing: Make sure the panel is flush the cabinet front and bottom. Paintable laminate comes in two thicknesses.

#PAINTABLE VEEER PANEL INSTALL#

Otherwise, install the entire end panel and cut it to fit once installed.Īdhering: Use contact cement on both the end panel and the surface you’re applying the end panel. Use a straight edge and scoring the panel with a utility knife before cutting. If the countertop is already installed then you’ll need to cut the end panel to the correct size using a table or circular saw.

#PAINTABLE VEEER PANEL FREE#

Surface Prep: Make sure the end panel and cabinet surfaces are free of dust/dirt before applying.Ĭutting: Use a router to cut the end panel to fit the cabinet height/width then hand file or use 150 grit sand paper to make a smooth edge. Apply the veneer strips to one opening at a time.Īdhering: PSA veneers have a pre-glued adhesive layer protected by a peel coatįinishing: Use a razor knife to remove the excess material and finish with a hand file or 150 grit sand block to trim the excess material. We recommend doing the stiles first and then the rails. Cut the veneer strips ½” wider and 2” longer than the area you plan to cover (stiles/rails). Use a tack cloth to remove excess dust.Ĭutting: Use a veneer/laminate slitter, rotary cutter, or sharpened utility knife/straight edge to cut the veneer. Clean the area and wait for the it to thoroughly dry. Lightly sand any surfaces you plan to cover. Surface Prep: Fill in any voids on the surfaces with wood putty. Suggested Tools & Materials needed to install Veneers/3D laminates and End Panels:Ĭritical: Veneers should be placed flat and allowed to acclimate for 48 hours before installation. When ordering end panels, choose your wall or base cabinet end panel size, choose your preferred wood specie, then add to cart.We offer 1 base cabinet end panel (24'W x 36'H).We offer 2 wall cabinet end panels (12'W x 30'H, 12'W x 42'H).3D Laminates come in 48' x 96' sheets only and does not have an adhesive layer. To paint wood veneer, repair any damage to the veneer, clean the surface well, sand it lightly, apply primer, and apply as many coats of paint as necessary.

PSA veneers have a pre-glued adhesive layer protected by a peel coatĬovering that must be removed prior to application.

PSA Veneer Sheets come in 24' x 96' sheets only.

Ordering your accessories is simple and easy:

Paintable veeer panel